AMF & Synchronising PanelsLocal controlManual
Start Stop Panel
The simplest generator control there is — start, stop, and the instruments to see what the set is doing.
Rating plate
Start Stop Panel
- Compliance
- IS/IEC 61439-1 & 61439-2
- Supply system
- 415 V, 3 phase 4 wire, 50 Hz
- Rated insulation voltage
- 690 V
- Ambient temperature
- 45 °C
- Rated current
- 63 A to 630 A
- Control
- Manual start / stop, local
- Instruments
- Voltmeter, ammeter, frequency, hour run, battery volts
- Protection
- Low oil pressure, high water temperature, overspeed
- Annunciation
- Audio-visual, with accept and reset
- Degree of protection
- IP42 to IP54
Specifying this panel
Specified where an operator is present anyway and automatic changeover is not wanted — standby sets that must not start on their own, or test rigs.
The engine protections are the same three that an AMF panel carries. Manual control does not mean unprotected.
Built for
- Attended generator rooms
- Test benches and load banks
- Portable and hired sets
- Backup to an automatic scheme
Fitted with
The assembly is ours; the switchgear inside it is genuine, authorised-channel product from the makes you specify.
AMF & Synchronising Panels
Other panels in this family.
Built to the same standard, and able to share a lineup with this one.
Auto mains failure · Changeover
AMF Panel
View more
8 sets · SLC 5/05 · One bus
PLC Based DG Synchronization Panel
View more
Auto start · Load demand
PLC Based DG Auto Panel
View more
Next step
Send us the single-line.
A drawing, a load list or a BOQ is enough to start. You'll get the ratings checked against the actual fault level, a general-arrangement drawing to approve, and a fixed price.